Is the way to polish the wiper reliable ?

The way to renovate the wiper by sanding the wiper is reliable, but it is very particular about the technique.


If it is too violent to polish, or if the sandpaper model is wrong, it is easy to deform the shape and surface of the rubber blade .



The refurbishment steps are very simple. First remove the wiper and clean it. Then fold the fine sandpaper into the rubber and fold it. Then use the water to wet the surface of the rubber. Use a fine sandpaper to rub gently three or four times from the bottom. Finally, rinse the polished particles and install them back on the wiper arm. Buy a wiper, first select topex !




Improper selection of glass cleaner will accelerate the aging of the wiper ?


This is a personal experience from some riders. The front windshield was cleaned with detergent. After cleaning, it was found that the progress of the aging of the wiper was accelerated, and it was not durable before. Therefore, it is best to use a dedicated vehicle cleaner .




How to solve the abnormal noise and beating problem of the wiper ?



There is an abnormal sound in the wiper, which may be due to the following reasons :


1. The rubber aging of the wiper ;


2. There is dirt accumulation on the rubber edge of the wiper ;


3. There is dirt on the front glass surface ;


4. The temperature is too low to make the rubber hard ;


5. Frequent use of wipers under abnormal conditions ( such as dry scraping ) .




If the wiper is abnormally sounded , the owner can solve it by means of “ smear toothpaste ”.


Specific steps are as follows :


1. Squeeze the strip of toothpaste on the corner of the wet towel .


2 . Repeatedly wipe the rubber edge .


3 . Wipe the cleaned black dirt with a towel .




To sum up :


As for the wiper, it can be said that it is a common problem. It belongs to the wearing parts. Basically, when there is a situation where the scratch is not clean and there is abnormal noise, it needs to be cleaned, refurbished or directly replaced .


In addition, our door does not have to specifically pursue the soft flat wiper blade . If the original car has a metal wiper blade , when replacing the soft flat wiper blade , also pay attention to the bracket pressure of the original car, so as to avoid the situation after the replacement is not applicable .








(TEL)86-592-2918292 ,6388105

E-MAIL: [email protected]




We are now looking for Global Distributors, Welcome to cooperate with us !



Email : [email protected] .

Website: .